Search results

anyone have an active Zoro coupon code?

I've got some 10' tall plastic storage tanks for ro water. I need to get a low water cut off switch in them. I don't like the idea of drilling a hole and threading a switch into the bottom of the tank. Is there a surface mounted "tape on sensor" style available? I've seen similar sensors on rv...

Epoxy concrete anchors vs wedge anchors...what has been your experience? I have some large menu signs and booms for free vac stations to install. I've never used epoxy anchors. Need to hear pros and cons from those that have. Thanks.

For those of you that have an employee handbook: Did you write it yourself? Purchase software, online service,?

What is the recommended pressure to run the ro production pump?

How can I set up my prep guns to turn on/off with the gun trigger?

What do I need to do this in a simple, inexpensive way (no plc's, etc.)? An 8 pin plug in relay?...but which relay?: I have 2 - 120v light bulbs. With 120v power applied I want one to turn on for 20 seconds. When it shuts off I want the other to turn on for 20 seconds. I want the cycle to...

In my touchless iba I have an airlift door motor on the exit side. I am replacing this motor every year or two because moisture is getting inside of it. We have tried caulk, etc. but still have problems. Any ideas on how to seal this motor up?

At one of my locations I have a gas station/c store on one side of me and residential housing on the other side. People from the homes are constantly walking across my parking lot in front of the exit of the tunnel wash to go to the c store. It becomes icy in that area (as well as all other...

A couple of my locations have a 4X8 2 sided backlit pole sign at the street. They have 4 ho fluorescent tubes and ballasts in them. These of course require maintenance and are difficult to access. Any ideas for replacing the lighting in these with LED? Maybe a couple small wallpacks, rope...

I am looking for a remote temperature monitoring device. Something that would send me an alert to my android phone when the temp. drops to a predetermined level and that I could log in and check on. I have wifi available where the "transmitter" would be placed. Any ideas?

I have some two sided 4'X8' backlit signs on tall steel poles. They are powered by 4 - 8' ho fluorescent lamps/ballast. Is there a better way to light these signs...LED, etc.?

One of my self serve washes has no bump posts between the bays. For the past 30 years I have used wooden 1/2 whiskey barrels where the bump posts would have been. Over the years I have put a variety of items in the wood barrels to dress them up...flowers, shrubs, rocks, etc. I'm tired of the...

I need a stainless steel enclosure to mount in the bays. It must be able to accommodate a credit card swiper and a push button. Access to the backside is needed in order to service and accommodate the swiper and button. The door does not necessarily need to lock, screws (electrical enclosure?)...

Anyone using one? Do you like it? How is customer support from Standard?

I purchased this floor switch to operate a cta in my tunnel. https://www.kleen-ritecorp.com/p-3699-ramped-floor-switch-9w-x-32l.aspx I am having problems with the vehicle rolling off from it thus becoming "disconnected" with the conveyor roller. Any ideas on a solution to this issue?

Have 2 prep guns at tunnel entrance. 3 gpm each. Any suggestions for a water heating system to supply them?

Can anyone recommend an emergency on/off switch to be used in a tunnel wash? I'm thinking red mushroom head, push/pull style possibly. I have used Schneider/Square D in the past but they are getting rather pricey.

Any recommendations for a cta unit and a treadle/tape switch for a conveyor tunnel wash?

What do you use for a prep gun on/off switch?