Search results

I am having an issue with a PDQ docking dryer that I cannot resolve and need help. Keep in mind I have a door option. After the last pass of the wash the Laserwash docks to the dryer, the trolley will move over to the right until inputs X23 and X30 are on. The arch does not rotate and if I am...

Does anyone know what would cause a "Measure Eye" fail on a Laserwash virtual treadle setup?

Anyone know what material the new Laserwash machine is made out of? Mild Steel, Stainless, Aluminum?

I am getting a Bridge Warning 153 on my G5 but I cannot find any documentation on this warning. Any help would be greatly appreciated.

Has anyone been able to communicate to a G5 with Windows 7?

I have been having an issue at multiple locations were the Laserwash will apply the first pass of presoak and when it gets to the passengers side front of the vehicle the spray arch will not rotate but will continue to spray chemical forever. The Laserwash will not go into a fault condition...

Can someone please explain to me what to look for when the trolley stops half way across the back of the vehicle, arch rotates, bridge goes forward and hits the vehicle. I am positive there is an issue with the VT measurement but I cannot pin point the problem.

I am having issues at a location with a VT board. Every once in a while when going across the back of the vehicle the trolley will stop half way across the back, arch rotate and hit the vehicle. I have calibrated sonars, checked X30 signal, replaced VT board and it still does it. I have even...

I am having an issue with an M5 on-board dyer. After the spot free pass I get water dripping out of the nozzles for what I consider a long time and during the dry with the arch pointing over the vehicle the water is dripping on the vehicle. I cannot have the arm pointing towards the entrance of...

I keep getting a warning error #5 (re-synchronized count) on a virtual treadle board and I cannot figure out how to fix it. The manual I have does not give me any troubleshooting info. Does anyone know what this error is and how to fix it?

I am having an intermitant problem with a Laserwind Dryer setup. The problem is actaully with the Laserwash prior to picking up the Laserwind. Under normal operation at the end of the wash the spray arm rotates to the home position and then the trolley moves to the right into its home position...

Is anyone experincing problems with G5 pump drives? I have a site were the pump drive would not start the pump. I tried multiple drives from PDQ and it would still not start the pump. The pump would stay in the stop mode. I ended up installing an older drive from a used machine I had and it...