Hi all I need help to drill out a few plug locks that thieves attempted to drill
I think it may have been randy who had instructions to do so.
If any one could pm me on this it would much appreciated
Thanks
Adam
Hello, hope this helps...
Secure pay did server upgrade that's why credit cards are not working.
All you have to do is change the URL to api.securepay.com.au/xmlapi/payment
You have to change it in payment.ini folder and then change it in swipe and clean utilities by pressing Ctrl U and change...
Thank you for your advice guys! It was the home prox that was faulty it was staying 'on'. On another note, do any of you keep a list of solutions for alarms? Thanks again!
I have a WW2.0 that starts putting presoak on the vehicle, but before it even gets to the front wheel it stops, doesn't go home, and tells the customer to exit (scolling sign & buzzer). The control panel has an error message alarm 1 that says: no motion detected Check for obstruction on gantry...
Hey, I ended up installing them on my water wizard 2.0 and they are great. Uses less water, less maintenance and cleaning of the nozzles. Great for removing bugs but they are a much noisier experience for the customer. Overall, they are much better than the original Coleman ones.
Hey guys
Any one got these Hydra-flex inc nozzles on there water wizards??
Blast-Tec 324 Pro Retrofit Kit - Water Wizard
Any feed back would be great
www.hydraflexinc.com/waterwizardretro
Thanks :)
The distributor in AUS says every 2 years. Theres been a couple that have hit cars here and its a big job to fix it coz when the boom hits the ground it bends the whole boom.
They are Metric timing belt AT10 open ended belt
AT10-25-OPEN 2x 2.5mtr lengths
Polyurethane with Stainless steel...
cfcw thanks for your reply
Yes production side of the RO system
The pump is nearly five years old. No one has played around with the regulator
I replaced the membranes around a year ago and the regulator with a stainless needle valve. After that the system work fine above 120psi and slowly...
The Sta-Rite pump Model: HPS10E3-01 on the JCC R.O. system has dropped pressure to 60psi. Normally it was above 120psi.
Is the pump the problem or is it something else?
Has anyone replace or repaired the pump?
Is there a rebuild kit for it?
Hey guys,
I have a four year old WW2.0 with 75,000 washes on it. Just wondering how often the boom belts should be replaced? I've heard of stories of them snapping during a cycle.