Search results

could someone please tell me what software version is needed to add 3x foam to a laserwash 4000 with an a-4000 controller

fairy tale ???????? not at all....... web site sba.gov/stimulus look for the section on arc loan $35,000.00 max, 5 year pay back. no interest. no payments for 12 months. should your bank help you with this loan ? a very big YES !!!!!! this loan is 100% guaranteed by sba. bank is paid prime plus...

i have a lw 4000 with a docking dryer. this machine will work fine and then generate a 30 pager code, dryer not at home. it seems like the dryer is not releasing at the end of the drying cycle and is being dragged an inch or two when the bridge is returning to the home position. i have replaced...

i need a set of mounting legs for a pdq laserdri dennis 304-670-8301 thanks

i have an acw with c/c. my problem is that 2 of the 4 button selections do not work. the buttons check out ok. is it the harness or controller?

I need to change the bearings on one of the producers on a lw 4000 docking dryer. (noisy) i can't find the bearing number on the pillow block bearing. (still in service) i would like to buy the bearings before i take the dryer out of service. anyone know what the brg. mfg. and brg. number would be?

i have a lw 4000 with a docking dryer. the magnets are not releasing at the end of the wash. any ideas? thanks

i have a low volume exterior wash. i am looking to purchase a new drying system. anyone have any suggestions? we do towel dry now. i would like to eliminate this service in the near future. thanks!!!!!!!

good morning. i am having a constant problem with "front eye and rear eye fail" error message with a 9 year old lw 4000. this machine will work fine for several washes and then the error meassage will appear. i can power down the j/o cabnet and the fault will not be displayed again for several...

Has Anyone Looked Into Adding Geathermal Assist To The Floor Heat System?

just some food for thought. i had a service call the other day on a 3 year old WASHWORLD HIGH VELOCITY machine. the main control cabinet got wet due to a hose break. dried out the cabinet while holding my breath expecting the worst. it must have been the operators lucky day. the only problem was...

i have a l/w 4000 that has a rear eye fault after washing about 15 cars. if i power down the j/o cabinet, the fault is gone for another 15 cars then returns. while the fault is present, all of the inputs, x-21 and x26 (mid prox) are working fine while washing a car, even though the rear eye fail...