Search results

water is backing up into my wax and hp soap chemical holding tank while using only rinse option (clean bay walls). There are no check valves. Manifold has coils and tubing goes to water holding tank and onto the pump. How is fresh water backing up to the tank? I replace the hydrominder still no...

i had to shut down mine. Too many people washing cars and they dont practice social distancing especially at the vac. I might open back up but without vacs.

wire going to the shallco was bad..replace wire good to go! thanks for the help.

na.. all wirings are on.

Thanks for all the replies. I had to buy shallco for a temporary fix. But i ran into a problem. i double checked with another bay wiring, I dont get any high pressure. I notice the foam brush and conditioner works but no rinse or high pressure functions. any suggestions?

One of my coleman rotary switch (electroswitch) lock tight (hard to turn dial knob). I bought a shallco rotary locally, the numbers are not directly on each hole therefore im not sure which hole is for which. Can someone shed some light?

our aeration pump runs 24/7.

i suggest you ask the company that will put in the reclaim system before your renovation.

This sound interesting. So is it better than cryptopay? Do i also have to replace all my 1034 timers from coleman?

Smell is usually combination of both sludge and water being stagnant. Use a floating aerator with pump should eliminate the odor but that is overkill over just sludge pit. We have a recycle system so floating aerator is a must. Doesn't your State regulation allow you to dry sludge in separate...

Replace them not worth repair. Price increase on slugbuster?? Its the almost same with sensortron insert only.

install crypto pay and pocket the rest 😇

I tried it both ways. I put one at the handle brush and one on top at the arm. From experience, the one on top of the arm always leaks after period of time then you end up replace it often. The cause is customers yank on hose which eventually loosen the swivel breakaway part. So i end up just...

has anyone install crypto pay for wash select 2?

i recently replaced my fusionx for efusion with wings. In comparison as for the delivery, i dont like it.

Depend on your setup, it is simple as typing in the ip address in the navigation bar on your browser . My setup has a netgear vpn router, so i have to type in ip address and port number.

Thanks Mep...which one? Do they correspond to each chemical holding tank?

Water seeping back into hp soap holding tank which dilute chemical mix. I don't see check valves on back side. I notice when I use rinse, it fill up more...but could be coincidence. Btw I already check hydrominder. Suggestions?

This regulator is releasing air on the bottom which is killing my compressor. Im guessing its dirty but i've never taken this apart. Anybody knows the model number for this filter regulator for fusionx? All I can read is AW40-N.....Z I search and came up several models. I need the correct...

always start troubleshooting with the "Alarm" on redlion. It gives you a starting point. It is likely the banner eyes, plus in the middle it does a reverse the rotation.