Recent content by wash4me

Wow, thank you for that information. Yes we are doing a double pass on the back of all vehicles . You said is my boom indexed properly? I’ve never heard this term. Is there a procedure for this? Do you recall the length of hose you were using or how much shorter it was than the one specified by...

Well this problem is back and it does seem to be more likely on small cars. What would be the solution?

We use simoniz correct powder soap from kleenrite for both passes on the high velocity. Add about half a gallon of foamed per 50 gallon drum. Cleans well.

https://www.mrheater.com/product/heaters/garage-workshop.html Dayton makes one and there are chicken house heaters also that have millivolt gas valves. I don’t believe any of those have a carbon dioxide sensor to shut the gas off. 30,000 is the largest one made I believe of the ceramic style...

Do you have heated rails?

Thanks, Can you tell me is how long is the blow down? Is there more than one blow down? Does it use full pressure compressed air? How big is the solenoid valve? Does it have a separate valve for the underbody and the L arm?

Thanks for the perspective. Did you have floor heat in your bay you had trouble with? I am talking about running one door so the wind would not blow through. The doors I have are 10 by 10. Where are you located? PM if you prefer. Thanks

Airlift doors where the plastic hinges have no aluminum left to bolt onto. My door guy said he needed to take the door out completely to fix it. Lag Remember here and he was manager for a number of washers where they have a system installed the blew down the bays. They are a few hundred miles...

I am wanting to install a blowdown system on a Washworld high velocity. My front door broke and instead of fixing it I want a blow down system. Anyone have a working system? I found some old post where Lag had success.

Is this kit available to purchase and if not what signal is used to start the blowdown?

Cap rate will be much higher resulting in a lower sales price on such a small facility.

Vilco has had three of my pumps for 6 to 9 months I think. I have always had good luck in the past. He told me he had a health problem and was slowly returning to work but has no way of telling me when he would get to my Pumps.

Ngeavemann I’m not following you on where and how to natal an L bracket.

I have medeco locks six of them we’ve lost the keys I see on here where people are asking for a private message on how to drill out the locks. I’m going to change the style of lock all together so I don’t need to reuse anything. It would be appreciated if someone would send me those...