Recent content by Jason Studer

Vitron is what Kleen rite suggests, for harsh chemicals. Dryer works fine. I did order a few dryers and will install right at the pump. hopefully that works. It's just weird that I never had this issue for 20 years and now the last 3-4 years I have nothing but issues. Thanks for input. Jason

I have a refrigerant dryer at compressor, and an automatic drain valve, I will try to add the modular air filter at flojet. It is just weird I never had this issue even before I add the dryer at compressor.

In the past four years it seems that the Flojet pumps are failing at a very high rate. I bet I am not getting 5 months tops out of them on the foam brush, I just replaced one that was only 101 days old. I do use the Vitron style. Kleen rite ask me if I use a Hydo minder, which I do. Not sure...

Mounds View Minnesota North of Mpls. 10 miles $2.00 to start for 3 min 28 seconds $4.32 for 7 min start up for CC I charge 8% CC fees Vacs $1.00 for 3 minutes Pretty much the same around town but all other washes start up for $1 for 1 minute 40 seconds and .50 cents on Tuesdays. There are...

I spoke with Jim at Etowah Valley, They will do repairs on them depending on serial number. Thanks for information.

I understand that IDX is out of business, but does anyone know who is if anyone is repairing them? I have a couple of MA-850's. Thanks, Jason

What are you pricing micro fiber towels at? I have never had them, but Customers have asked Me to vend them.

I have sent the readers in at least five to six times in about the six years I have had them. I only have four bays and purchased two extra so that when they are down my bay isn't down for CC. Now I have one that they won't repair and one that the button does not light up, but still works. Not...

I am being told that they are no longer repairing any readers with serial number SW 16000 or lower. those are roughly 5 years and older. Is there anyone out there repairing them besides them? I have four readers that are from around that time and don't want to spend $400.00 every time one...

Yes it has the counter weight set up, not sure how your strapeze work but I do believe they are the same. Setting the eye angle is not an issue, they have a very wide range. That's not an issue, and there is a lock out system once the doors are shut. So if someone or something break the beam...

Fails to close 100% of the time. You can pull out the amplifier and they will operate on the timer but no protection if the door comes down and a car is driving out. I'll shut the bay down before I would run like that. Fortunately I will get a call from my alarm company to notify me that a door...

I"m at about 5 grains before softener as well, and 0-1 after. When my 30 year old softener took a crap a couple years ago, for three weeks I had to bump up my soap to like 35-1. The soap cost was killing me. I have done the math and the softener paid for itself in less then two years, Just in...

Sounds like you got it figured out. But I would do as Bob said earlier when you get a chance and check your water hardness. 25:1 is a lot of soap. I run 150:1 and it suds up like shaving cream. I get it every soap is different, but if your water is even a little hard a $1200.00-$2000.00...

I do let customers open and close doors during the warmer weather. I am setting it up so the that all door will automatically open and lock up at 9pm and go back to be used at 7am. This way the Police can drive by and see what is going on at night. It just turns into a wind tunnel and dries the...

We have open and close buttons that the customer would push to open the door at the entrance as well as open and close door buttons inside the wash for both entrance and exit doors. we have tandem bays. all door are on timers entrance and exit, all set at 30 seconds.