What's new
By:
Car Wash Forum

This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

LW turning too early, when coming up

Has VT, but can't remember the version. I am stuck at school all day, then away bb games tonight.! My employee is going by after while...
 
i had the same problem last month
i thought the home flag 30mm was going off and tricking the machine
so i changed that and the festune wire
still did it
so i changed the front eye still did it randomly
so i put the amp on the rear eye and it guess what starting turning early on the back
try the x40 amp in the j3
for a quick check just swap the two out and see if it follows to the rear eyes
good luck
 
No, it goes across the back, then turns early, to go up passenger side. It does seem to turn, to go up, about the same area though...
 
Mine did that awhile back but was on the front
my impact switch would shut it down
and i noticed the left limit eye was on, it was really cold that day so i wiggled it and then actually hit the back part of the plug with my wrench and it went off..........so anyways bad eye
next time it happens see if your right sensor is on in gantry or in jo
good luck
 
Not yet. PDA told me to change out trolly relay, 24v. So I ordered that yesterday. STILL RAINING here in E Tx!!
What's your thought on trolly relay?
 
Check your x30 prox, if it's damaged, replace it, replace the x30 prox cable, also check for a bad connection and corrosion in the junction box. If you still have an issue, you may have a bad wire in your festoon cable. Good luck..
 
You must log in or register to reply here.
Back
Top