poolenglish
New member
my hamilton goldline has criptopay swiper and tap. it has worked for months since installing the tap pay. Now it does not issue the wash but charges the credit card.
BUT the pay station accepts cash or paper tokens and issues a wash like normal.
1.... I checked voltage on 1 of the transformers and replaced the bad transformer that powers(i was told by hamilton) the heater and the readout AND the swipe,and tap from cryptopay.
J18 connector
the transformer that I replaced is slightly lower VA (40va compared to original is 55va) both are 120volt to 24volt ac........... this one from amazon sunday emergency purchase >>
2- I tried to issue a wash thru cryptopay to the bay and was unsucessful. I used my charge card many times and it takes but does not send the command to the car wash to green arrow to start wash (but it does charge my credit card lol $60+ so far lol)...
3 the problem must be the transformer OR something with the computer board? my guess is that the replacement transformer that I installed is not (va ((volt amp)) ) large enough amperage to send the command to the wash machine and it is enough amperage to run the swiper and tapper (which was wired in ; a non hamilton authorized accessory).
#3 so I suspect that we need a transformer from hamilton?
ANY suggestions what the problem can be? it is a sunday and we are getting busy and i need to get her going asap. thanks Pat
BUT the pay station accepts cash or paper tokens and issues a wash like normal.
1.... I checked voltage on 1 of the transformers and replaced the bad transformer that powers(i was told by hamilton) the heater and the readout AND the swipe,and tap from cryptopay.
J18 connector
the transformer that I replaced is slightly lower VA (40va compared to original is 55va) both are 120volt to 24volt ac........... this one from amazon sunday emergency purchase >>
2- I tried to issue a wash thru cryptopay to the bay and was unsucessful. I used my charge card many times and it takes but does not send the command to the car wash to green arrow to start wash (but it does charge my credit card lol $60+ so far lol)...
3 the problem must be the transformer OR something with the computer board? my guess is that the replacement transformer that I installed is not (va ((volt amp)) ) large enough amperage to send the command to the wash machine and it is enough amperage to run the swiper and tapper (which was wired in ; a non hamilton authorized accessory).
#3 so I suspect that we need a transformer from hamilton?
ANY suggestions what the problem can be? it is a sunday and we are getting busy and i need to get her going asap. thanks Pat