Search results

Do you mix this with 10 gallons of water before you put it to the Hydrameter like kr concentrate or just run straight? Thanks

I use a syringe and maybe add a little hose to it to get in the hole they couldn't've have put them in a worse place

Thank you I understand that my question is is that all the pieces there is to it the bearing then the cap a washer a lock washer and the screw? Just making sure I'm not missing a piece thank you

Time to change the rollers on this machine the other machine has rollers that have greaseable shafts this one has bearings is this all there is to it or is there something missing What I'm seeing is two bearings one on each side some sort of cap a washer a lock washer and a screw it's worked for...

THANKS FOR YOUR HELP Anyone travel to 44906 to replace a gear box im strapped for time be happy to pay someone to come change it out thanks

Thanks, tire pressure ok.. Think its gear box few weeks ago idiot with a truck and ladder rack got wedged in it almost tore the whole machine out of the ceiling. Its only locking in place when u push it towards the exit sometimes mostly if u put alot of pressure on it u can roll the...

Hello, My 4000 is drifting in the home position its sensing the front limit its lit on the gantry but its rolling past the flag sometimes which in turn activates the rear limit when it goes past frnt flag. Sometimes both rear and front are on if it catches them just right and then locks...

Thank you everyone for the input. Ill take apart this weekend and keep ya posted. Also found an older thread with similar in the spot free section. Thanks again. Most likely swap out for a starite hp10e3112ma1 would this be sufficient ? I would assume it would at least be better thanks again

I had a pump before at a location that you couldn't just hook up and turn on the only way I can get it to push at capacity was to turn the 1-in hose on turn the pump on and magically put them on together until it suck just right to prime itself otherwise it was kind of the same scenario it would...

Shaving cream around fittings checking for air 😁

.

I Bought the wash like this previous owners Over 30 years old all kinds of fun mods and handy man specials. No regulator it just turned on and would run around 40psi which was sufficient enough for a fan at bays obviously not the best pressure but no complaints I changed the solenoids u see...

I think the pump is just shut got to be 10 years old I was there when I bought the car wash. Any suggestions on a new pump since I have to go buy one I'm assuming I should probably look for something that's about 200 PSI looks like this pump's running it to 220 and does not have a shut off...

The big line feeds autoya I know it's not ideal. Solenoid is closed so no leak or sharingthanks

The triple foam tends to mix up and ends up turning brown half the time. Looks great when it works properly. I got tired of it so I just run one color but people love it make sure your throwing shaving cream and they will spray it all day. Dryers work great specifically with cc patron. A...

Hello This is what I use for my spot free pump. I had to change the solenoids Couple months ago. Pump is only putting out about 20psi. Question -does the pump production go down after years? -maybe it's not primed well? I use to have a fan spray no more of a P🥺 Thanks

Take some of your soap and pour it straight into the Hydra tank or squirt some Dawn dish soap in there. If you get soap at the gun then you know it's a solution problem.

Shut the product off and crank up your air and see if you're getting air at the brush Had a problem like that before the foam generator block dema 93.27 in the Attic was stuck. Wasnt letting the air out. It was letting a little bit of air out but not nearly as much as it should have been for...

?