Search results

When I try to sign in to connect to the Viper board inside the (JO) it will not allow me anymore. Normally every morning i log in to check on daily counts.M5 works perfectly just cannot make a connection. IP address is correct changed cable,different computer with correct IP. Any suggestions? I...

I was wondering if anyone knows what turns on the rail heat my weep turns on and off. Is it also controlled by my bay temperature probe?Heaters work when bypassed can't get contactor to close. Thanks Liberty

I am having a problem with the M5 when the wash is completed the wash does not go back to its home position. laser stays up front need to reset machine then all is fine. It does not happen continuously Error code says stuck in bay exit outside eye 1 sensor on. any info would be appreciated. The...

Having problems with my Laser 4000 with motor run on it seems to be happening in the same two locations each time. Wash will start as usual go across front of car down the driverside arch turns to do rear of car and stops there no movement,the stop light indicator goes blank and the Laser needs...

I have a pdq m5 i am have a error that says illegal move extent when trying to move bridge from rear of car to front.It will not allow it to move i can move it any other position.Any suggestions?THANKS MIKE LIBERTY CARWASH CHICAGO IL.

I'm still having intermitten problems with my Laser 4000 stopping while washing cars .Lately read out is arch rotation error.and a fl2 on speed controller only when you try to reset at joy stick.I you look at ABB display its 00 than try to move in any direction goes to fl2.but it will not allow...

Im still having problems with laser intermittenly stopping during any wash cycle.when we try to reset machine bridge will not move trolley or arch rotation wont budge.Today ABB speedcontroller says fl16.Had service out last week 6hrs later could not get it to fail while they are there.Sometimes...

Has anybody had a problem with laser where wash stops in different locations while washing,try to reset laser with joy stick but nothing moves can here contactors pulling in but no movement on trolley ,bridge or arch rotation.than after a while it will move than stop again.fl 2 on speed controller.