Recent content by washzone

I have been using cassida c 100 for 7 years and works good for me it is $150.00 from amazon

car wash and laundromat for sale in Lewistown,IL see listing on remax

a couple years ago i checked out clear token pay by phone app it is basically plug and play idx i believe has teamed up with them, seemed pretty inexpensive

I got an email from airlift doors saying they now have parts for ultimate doors

X-cell electronics of Las Vegas, NV Dan is awesome his phone # is 702-889-9235

I would also like to see a pic of this mounted on your acw Thanks

we have some hydro spray parts, where are you located and what are you looking for

Thanks all for input, Mep, We are using scotch plaid tunnel pro basic conditioner #191 low ph i know you said only one to use would be dyna pac foam brush but in their catalog it says that is for self serv so it would be ok for in bay touchless? Your advice and tips are always priceless thanks...

scotch plaid

What is considered the right way to apply triple foam? Apply on top of pre soak one and pre soak two then rinse all or rinse off pre one and two then apply tri foam or apply tri foam first before pre soaks?

Last year i remember a post about changing weep miser settings for p1, p2, and p3 to 30 seconds instead of one min, i cannot find it again, I was trying to find at what percent the weep would run at each setting

A few years ago we thought about using awesome in all of our washes but wasnt sure if it would be ok for cars, as i had used it to get old wax of floor in our laundromat that we had just bought and it was the only thing that took it off, it was black and had been on the floors for who knows how...

Thanks Soapy Looks good

Thanks Soapy for your quick response wondering if you have pics of your install

Soapy thanks for sharing, can you tell me if you installed it opposite of what Garadry says with the hump being on the inside of the bay instead of outside, my thought is it would be the opposite of what they say to keep water in the bay, also i wondered about putting heat tape through the holes...