Recent content by SudsnShine115

Just wanted to share how the move went. We switched the two outside blowers. Gained an extra 28" for the machine to move. Seems to dry a lot better.

We have added an Ice Vending machine, and an air compressor stand for filling tires. The compressor is brand new so its still gaining traction. Mainly put it in so now offer everything the closest gas station offers on the car washing side. The ice machine does great in the summer, but super...

Glad to hear, we are definitely looking into getting it all moved, probably after pollen season. What contributes to the greater through put, the fact that the next car in line can start the wash sooner? Also just curious what switching the fans does to increase drying? I was planning on doing...

I came across some dryer silencers, but don't know if that is something we can add to ours. I think our location would be fine with the noise, there isn't any one close by to bother.

Thanks for the input. Does moving them outside the bay improve throughput because the next wash can start sooner? Also, does flipping the outside dryers allow for better positioning to improve drying?

The reason I asked about pointing them straight down is if we move them closer to the exit, we either have to move the outside or would have to move to two outside dryers in to get enough travel for the machine.

We had considered that as well. Would have to buy a new stand to place them out there, but might be a better option.

We had a MarkVII choice wash installed in March of 2022. One thing I wish we did when installing was move our old dryers. We want to move them toward the exit more, so we can extend the travel of the machine. Currently it doesn't do a great job on the back of a longer truck or SUV, we need about...

I just spoke with the technical service this week, and had a few questions they were able to walk me through on the phone. Working on getting a custom display done, which they charge for but think it will be a better display for customers.

Still haven't figure out what our issue is with this. We hooked up the Weepmizer which has been great to manually turn on the weep, and know the solenoids are doing what they should be. I know we have water running to the block that is connected to the hose that goes out to the bay. I tested...

Still trying to trouble shoot. We hooked up the weep mizer which is great because we can manually turn it on or off to troubleshoot. The main rinse solenoid we took off and it had some build up in it, so it wasn’t flowing nearly enough water. Thought that was the fix, and it helped because more...

We hooked up a new temperature control, that was for our old automated. This is wired right into the pump stand. Stumped on why the weep isn’t turning on. Worked fine last year. I will try to get on the phone with Ginsan tomorrow.

Not sure if if we have needle valves. There is only one solenoid on the back of the unit, which didn’t seem to be clogged and still working. We turned up the temperature yesterday to try to get it to weep, and only bay 1, which is closest to the equipment room seemed to weep. The rest of the...

We had our first consistent cold weather in NC this weekend, and our wash froze. Our Weeping worked as needed last year, but isn’t working right now. We have a ginsan ultimate pump stand that runs the bays. The bay closest to the equipment room partially weeps, but the rest of them don’t seem to...