Recent content by hoyeman

Thanks MEP, Is there a brand that you prefer?

I am switching over to a tankless system and will have my wax and rinse setting open one solenoid valve for cold water. How to I make sure my solenoid that allows wax to be drawn in doesn't open when the selector is set on rinse? I am picturing the current going to the cold water solenoid and...

Thanks mep001, I wasn't getting along to well with the search engine prior to my post but went back a tried again and found a bunch of helpful info. I'll be back with more details if the info does not work.

One of my bays has lower pressure at the wand. I replaced the tip and nothing changed. Any ideas on what is causing this before I start randomly pulling things apart? Thanks David

Any one have a good lead on insurance for a ss and detail combo situation. My agent works with 2 different companies that will not insure both. Thanks David

50%+ operating cost increase with a 12-18% gross decrease has got to be painful.

I saw the other day that retail is down from 5% to 25% with high end being the worst except walmart. And I hear McDonalds is doing well. I am thinking it is time to look at the unlimited time model again. I have always felt that my wash is a good canidate for that to begin with. I would...

I am putting up an awning/carport type stucture at my 4 bay ss wash and will have room for detailing. I need some suggestions on where I can get trained in detailing. I was thinking of finding a place that has some type of certification for the advertising advantages. Thanks David

Thanks for the link. The ICA has a statement that there are an estimated 22,000 car washes.

Hi, How do I find out how many car washes are in the US? All types combined? Thanks David

I have one alert horn that has current running to it and is constantly buzzing. It is connected to Dixmor led7. Anyone have any experience with this? Everything else works perfectly. Thanks David

ok call me stupid if i didn't figure it out but when I first saw that there was specified torque and I looked at the t handled, specialized tool I thought it was a joke one of the cat technitions slipped in there. Is there a specialized torque wrench also?

The bypass question was based on confusion. The 0 pressure regulator was being mentioned just before the mention on the bypass on the regulator. At first I thought that you were talking about the same regulator, the 0 pressure, and that it had some type of bypass(Never used one and never seen...

Can I replace my Cat 530 with an Amimitsu 313 and can I use the pully that is on my cat. Thanks David

0 pressure set up I saw on the Windtrax site that there is a weep and non-weep. Is the weep needed and is this what is being refered to as bypass that is going back into the intake side.