Recent content by Austin.james96

Update Turns out switches are fine, the hot water storage tank hydrominder 571 was not allowing water in the tank. It would actually hang above the water without enough weight causing the water to run low, tripping the low water level switch. Any recommendations on what supply valve I should go...

Thank you, just signed up. I’ve been at it for 3 years now, and I’m just now finding out about this

Awesome, thanks! Where did you get this diagram? I have no access to any of this info, and I’m sure it would help me down the road! Also, just curious. Would the spot free low level sensor cause this issue also?

Yeah, that’s what I was thinking. I’m not sure why it would be tripping the over load though. The motors seem to be working fine, no signs of over heating or anything like that. When i first noticed the issue, I was actually doing a cycle of test on the self service, and like I said before it...

I’ve got a signature series by Ryko, I’ve got an issue with my motors I believe. I can run the self serve like normal using the high pressure rinse, or spotless. Not all the time, but occasionally, all the motors will stop. Timer will still be active, can still use everything else but anything...

Luckily this place is not far at all from me, I will Definitely check them out for the price it’s worth a shot at least appreciate the advice

nice, thanks for the info! would you recommend the wash card bay station?

was this also your issue with your signature series when you said you had the same problem?!

Excuse me, i meant to type 24697* and not 22697 for the first part number!

Yes, I do. I have 4 bays and each of them have a ryko coin box. I believe i may have found the problem.(not sure completely, id like to get some more input before i order a the parts). I have found that the PCB Expander Assembly(224697-001) has quite a few spots that have definite shorts in it...

Hey guys, I’ve got a Ryko signature series self serve station. I had this issue with bay 3 with a solenoid that was bad holding my valve open. Before I ordered the block with new solenoids/coils I was tinkering with it and pulled the solenoid/coil off and went outside to mess with bay 3 from the...

I’ve got the two digit display, I have yet to see a code. I’ve not even been able to make this issue happen on my own. Out of 100 washes it’ll only do it 2 or 3 times and thats It. I’ve yet to see a code show up

That’s what I was thinking which is why i’m working on replacing the second prox. switch, or upgrading. I’ve heard that the ryko floor switch system isn’t really all that great. I will check out the switch’s threat. Thanks for the reply, greatly appreciated

Hey guys, so I’ve got a ryko soft gloss Maxx machine. I’m some what new to the car wash business but I’ve got an issue. Ever since I’ve started last october I’ve got one particular issue on my mind. Occasionally someone will be getting their car wash of course, and the machine will just stop...