Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
WW 1.0 is not cleaning the back
- Thread starter wash-man
- Start date
robtl
central Ky
are you using two step presoak or single pass hi ph,? does it do it on all wash programs?
Yes I am using a 2 step presoak. It is doing it on all the washes also. I switched to my winter receipe to see if it was a programming problem but that was not it.
It is spraying on the sides at the back of the cars but the boom is not spraying any soap at all. Should it the side stop spraying when the boom comes down? It does on the other automatic.
I was told that there might be air leak?
It is spraying on the sides at the back of the cars but the boom is not spraying any soap at all. Should it the side stop spraying when the boom comes down? It does on the other automatic.
I was told that there might be air leak?
robtl
central Ky
check to see if the presoak hose kinks when the boom turns towards the back of the car, it might have slipped in the hose clamp that holds it.
this is if the boom is turning forward and back OK
on ours we had to add a relay to cut the sides off when the boom comes down it did not come that way ,but I think it is programed on the new machines
toddmullens
Active member
You might check the presoak solenoid valves and make sure they are wired properly. Sounds like you might have them switched up if the sides work instead of the boom when at the rear of the car.
