toddmullens
Active member
I have a machine thats older than dirt and very little documentation that i am having issues with and was wondering if any of you had any ideas where to start troubleshooting. I randomly get a Drive cannot move error message and the machine stops. It's usually in the rear of the vehicle when the top brush is down. I have checked the drive motors and wheels, and all looks normal. The keys and keyways are good, bearings are good, etc. I can usually hit E and it starts right back up. Could a bad com cable cause this issue or is it more likely a counting prox or something? I do not have a manual to point me to all the causes of this particular error, so it makes it hard to diagnose, especially when its randomly occurring.
