Buzzie8
Member
I just bought a used weep mizer. I have two washes and the one already has a weep mizer. You would think that I would have no problem wiring it because I can look at the other wiring but one thing is throwing me curve. There are a total of three wires coming out of my existing one. One goes to the sensor. One goes down to a solenoid to open the weep. And a third (the one that I think I will not be using goes to an old anti freeze system from Mark VII that is not in use anymore. I am assuming that I wire it the same way but leave out the antifreeze lead. I need some affirmation of this. The Dixmore manual doesn't seem as thorough as I would like on this (or I am too stupid to understand) or both. If anyone knows please advise, a sensor form Kleenrite is being sent to me tomorrow.
Thanks,
Buzzie
Thanks,
Buzzie