Washworld Razor question

[copperglobe]

Question on a setting that I'm wondering about. Car 1 is in the bay getting washed. Car 2 comes and pays for the next wash at the autocashier- "please wait". Little sign outside of wash (green and red light) the red light is on. Car 1 finishes his wash and pulls out of bay. Little sign red light goes out. 8 seconds later that green light on the little sign comes on for car 2 to enter. It's not a autocashier problem as the "wash enable" circuit takes the 8 seconds to change- telling the autocashier to send in the next wash.

Is there a way to make that green light come on faster after car 1 leaves the wash?

 

[Roz]

Delay Enter Wash until Dry Complete
Your setting is probably ON

Set it to OFF if you want no delay between cars. When car is finishing dryer the next car is told to start. Works fine for us in multiple locations.

Found in General Options page 1 of 4...

 

[22MVR22]

The Razor also runs a start up test after every wash to make sure everything is in it's proper place, which will take a few seconds. Also, If you have any wash packages that end at the rear of the car, this may be the time it takes the Razor to travel back to the Home position at the exit end of the bay.