Vac it Up motors

[DiamondWash]

Does Kleen-Rite sell the bypass vac motors for this system or can I use another bypass vac motor instead of buying them through Vac it up?

 

[MEP001]

I think they do - I know Windtrax has them.

 

[6t7gto]

I buy my vac-it-up motors from Kleenrite.
Are you sure you don't just need to replace the brushes?

David

 

[DiamondWash]

What's the part # for the motor? This motor that died had a new set set of brushes on it.

 

[6t7gto]

Sorry for the delay. Here is what I use...
http://www.kleen-ritecorp.com/p-2426-lamb-ametek-116565-13-57-dia-3-stage-120v.aspx

david

 

[waright]

i bought the domel repalcement from windtrax, but it did not work on my vac it up system. The bottom of the domel motor is not completely flat, so it did not seat up tight to the bottom of my quarter box.

 

[MEP001]

The bottom of the domel motor is not completely flat

It should be - it might have been damaged in shipping. UPS is so rough with packages that when I order Domel motors I have to tell them to ship them on their sides, otherwise the bottoms are damaged when I get them.

 

[waright]

mep, these are the tangential bypass motors and I think they are built with slightly coned bottom. They work fine if you would put them on a vac with the normal hole in it. However on my vac it up system , they just drilled little 3/8 inch holes into a flat piece of steel, and the vac motor pushes up against the flat steel.