Keith Baker
Keith Baker
Hello all:
I have a Takagi T-K2 that won't fire up at all. It's used for my floor heat. It has full flow going through it, and the power source is verified. The control board green light is on solid, but no red light at all. There is not a code combination like this in the owner's manual.
I don't know if Takag will respond to a "non professional" service tech (me), but I'll call them later if I get time.
This unit has run trouble free for about 12 seasons until this happened, so I have no experience in working on it. I did check the high limit switch and it was good.
TIA:
Keith
I have a Takagi T-K2 that won't fire up at all. It's used for my floor heat. It has full flow going through it, and the power source is verified. The control board green light is on solid, but no red light at all. There is not a code combination like this in the owner's manual.
I don't know if Takag will respond to a "non professional" service tech (me), but I'll call them later if I get time.
This unit has run trouble free for about 12 seasons until this happened, so I have no experience in working on it. I did check the high limit switch and it was good.
TIA:
Keith
