We have a ryco soft gloss that we have a couple problems with. I get a code 33 and code 88 often. When its shows code 33, the book just says it not in home position. The machine is at the back of the bay and it stops there on the cycle the top brush is on. The top brush goes down the whole car and stops at the back of the bay and does not lift up and shuts down at that point. The code 88 the machine is at the front of the bay in the home postition. Now the door question. For automatic doors they are not coming down when the temp outside gets cold enough the inputs are on in the panel but no out puts. Is there a jumper wire needed for this or something different? I appreciate any responses and thank you.
Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
ryko soft gloss problems
- Thread starter brascoe
- Start date
DiamondWash
Well-known member
The top brush issue is the "Top Brush Solenoid" needs to be replaced if you need to know where it is let me know and that will correct that problem. As for the doors do you have "F1" blinking or turned on in the control panel where the -- or your 2 digit display is at?, if not the doors will stay open until this is turned on.
DiamondWash
Well-known member
It is in the right side panel of your softgloss behind the right rear brush open the panel and a host of gauges with be in there, it should have a sticker saying "Top Brush" or "Top Brush Solenoid" on it I have included a picture of it I recently had to replace the same Solenoid myself.
