What's new

Rico signature series self serve not responding

DiamondWash

Well-known member
Joined
Aug 31, 2007
Messages
2,364
Reaction score
461
Points
83
Location
Des Moines, Iowa
One of the PCB boards is bad and EXPENSIVE to replace if you can determine which one, I was done chasing this problem down with my Ryko Equipment and replaced my doors with the Ginsan replacement faceplate.
 

Ryko CS

Active member
Joined
Apr 23, 2012
Messages
349
Reaction score
88
Points
28
Location
Grimes, Ia
Those keypad timers should be able to power up without anything connected to it. I'd power down that coinbox, disconnect the additional cables except for power, then try powering it up. Next, I'd try to get into programming mode. Press and hold the MODE, and SELECT buttons simultaneously. While holding the MODE and SELECT buttons, press and release the RESET button. Continue to hold the SELECT and MODE buttons until the MAIN MENU appears on the display. If that doesn't appear, you likely have a timer that's been shorted out. It's possible it could be one of the other boards, but I'd test that timer first.
 
Top