PDQ G5 Bay error 30

[carwashn4fun]

Can anyone tell me what this error means?

 

[newhampshiretech]

they dont list a #30

Bay Error Text
1: Fuse Blown
Displayed during each star-up sequence, or power is off to pump node.
2: Disable Outputs Active
This is displayed during each star up sequence.
135: No Comm Buffer Err
Node chip is corrupt.
136: RS 485 Timeout
Width Sensors disconnected or incorrectly wired or failed.
137: Disable outputs true
Will be seen at start up, or when ever voltages on back plane not right, output card shorted, or back plane shorted.
138: No US Sensors
The width sensors were not found. Loose wires or bad sensors.
139: Too Many Sensors
Too many right or too many left USS‟s
140: No Comm
No communication to the USS‟s
141: Bad Timeout
Communication with sensors timed out. Bay Warning Text
1: Reset
This is displayed during each star up sequence.
2: Default Rack Config
This is displayed during each star up sequence.
3: Default Constants
Seen at startup, means the node is initializing
4: Wrong Table Length
Only at startup, means the node chip is corrupt
128: Bad Measurement
Width sensor measurement that is too short or too long.
129: Bad Temperature
Abnormal temperature received from width sensor. Bad sensor.
130: Bad Response
Communication problem with width sensors, check sensor and wiring.
142: Wrong State
Corrupt node chip.
143: Dipswitch Setting
Corrupt node chip.
255: Unknown Cmd
Means communication with conductor or node chip is corrupt.

 

[carwashn4fun]

Thanks for the information

 

[Mike]

Can anyone tell me what this error means?

I am assuming you ment a warning 130, a there is not any 30 error.

This Warning 130 Bay indicates you are having issues talking to the UltraSound sensors located in bay for measuring the sides of the cars.

Please feel free to call PDQ Tech support to discuss.