ken-pro
Equipment Distributor
Hello,
I am hoping to tap into the knowledge of some Mark VII techs / owners. I am helping out a customer who bought a used Aquajet Merchandiser which was factory refurbished about 5 years ago.
Some History:
Customer removed machine from a car dealership, and installed it himself into new bay at his wash. I supplied auto cashier, and offered as much help as possible.
With some effort I was able to reconnect necessary wiring - Customer didn't really mark the wires very well and install manual was a little vague.
I know that the exit end limit switch is faulty, and sending a signal all the time. By disconnecting I was able to go though the self testing for the motor pump unit, and the machine movement using the test function and reset button / treadle - With the switch connected the movement test doesn't work (Thinks its at home all the time) - I will be replacing the switch in a day or so, but I have re-connected it so machine thinks it is home.
The issue I am having is that when I load a wash, the display for remaining cycles works correctly as do the signs above the gantry for wash options - But when a vehicle parks on the treadle the signage still says drive forward, and the wash never starts moving. I know the treadle works because the input light responds correctly, and the movement test works. I believe dip switches for the wash packages are set correctly, but I only tried one wash package.
I am hoping for a little insight into what I should be looking for, and some troubleshooting help. Thanks
I am hoping to tap into the knowledge of some Mark VII techs / owners. I am helping out a customer who bought a used Aquajet Merchandiser which was factory refurbished about 5 years ago.
Some History:
Customer removed machine from a car dealership, and installed it himself into new bay at his wash. I supplied auto cashier, and offered as much help as possible.
With some effort I was able to reconnect necessary wiring - Customer didn't really mark the wires very well and install manual was a little vague.
I know that the exit end limit switch is faulty, and sending a signal all the time. By disconnecting I was able to go though the self testing for the motor pump unit, and the machine movement using the test function and reset button / treadle - With the switch connected the movement test doesn't work (Thinks its at home all the time) - I will be replacing the switch in a day or so, but I have re-connected it so machine thinks it is home.
The issue I am having is that when I load a wash, the display for remaining cycles works correctly as do the signs above the gantry for wash options - But when a vehicle parks on the treadle the signage still says drive forward, and the wash never starts moving. I know the treadle works because the input light responds correctly, and the movement test works. I believe dip switches for the wash packages are set correctly, but I only tried one wash package.
I am hoping for a little insight into what I should be looking for, and some troubleshooting help. Thanks