Ultra Shine
Member
I recently installed a used m5 that was running when I removed it.
The unit stared and run great.
About a week after we installed it on a Sunday it went haywire
Every node had a com error and the door kept going up and down.
I disconnected every cat 5 line and re-connected them. And did a test 90. Everything seemed to be ok
The next few days I kept getting a pump node com error. I swapped the cat 5 line and restarted everything. We were good for a few hours.
PDQ did some reconfigurations and we thought it was fixed. This Monday, ( about 7 days after the first round it did it again.
Put the unit in maintenance mode and did test 90. All good
Pdq suggestions was disconnected it from the internet .
One other note. Sometimes it will not come out of maintenance mode , it will show a red X in bay and it is out of maintenance mode but will not operate. Basically the horn doesn’t honk and the bridge doesn’t move to the home position.
Anyone have an idea
The unit stared and run great.
About a week after we installed it on a Sunday it went haywire
Every node had a com error and the door kept going up and down.
I disconnected every cat 5 line and re-connected them. And did a test 90. Everything seemed to be ok
The next few days I kept getting a pump node com error. I swapped the cat 5 line and restarted everything. We were good for a few hours.
PDQ did some reconfigurations and we thought it was fixed. This Monday, ( about 7 days after the first round it did it again.
Put the unit in maintenance mode and did test 90. All good
Pdq suggestions was disconnected it from the internet .
One other note. Sometimes it will not come out of maintenance mode , it will show a red X in bay and it is out of maintenance mode but will not operate. Basically the horn doesn’t honk and the bridge doesn’t move to the home position.
Anyone have an idea
