laserwash 4000 triple foam settings

[sterlingh20]

How much time should be on each of the tri foam settings? It is under automatic options on the lasermind.

Tri color fill delay timer
Tri color start delay timer
Tri color blowdown timer

 

[koliver]

These settings are site specific, depending on the length of the lines from the equipment room to the bay.

Tri Color Fill Delay Timer - This is the amount of time required to fill the lines. With the lines empty, turn on the 3X, count how long it takes to reach the manifolds in the bay. This would be your setting.

Tri Color Start Delay Timer - This is the pause before it starts moving to apply the 3X. This will depend on how long it takes to develop a pattern.

Tri Color Blowdown Timer - Must be set to 0 if you are using the 3X weep.