Waxman
Super Moderator
I greased the bank of 10 zerk fittings inside my gantry this morning, as well as the oscillating parts for my top blower.
How much grease should I use per fitting? I used 2 full pumps of grease each.
Is this enough? How do I know?
The fittings on the block in my gantry go, via plastic tubing, to points along the gantry (bearings for wheels, where the arm slides in/out, etc.)
I've heard over-greasing is bad, but how do I know if I am over-greasing things? How is over-greasing bad?
Thank you.
How much grease should I use per fitting? I used 2 full pumps of grease each.
Is this enough? How do I know?
The fittings on the block in my gantry go, via plastic tubing, to points along the gantry (bearings for wheels, where the arm slides in/out, etc.)
I've heard over-greasing is bad, but how do I know if I am over-greasing things? How is over-greasing bad?
Thank you.