G5 Issue

[blake247]

When I got to the wash this morning, I noticed both of the inbay says were flashing on and off. Oddly the dryer timer was stuck on "55" seconds. The error Im getting in maitnenance mode is:

-Bridge in ERROR
-Impact Sw Active

Any suggestions on what's causing this?

 

[koliver]

There is an impact switch right above the arch. See if the little yellow light is on. If it is not on, the impact switch has been activated. From maintenance mode, you can also test the input by doing an IM231 or IM236 (don't remember off hand which one it is). The arrow on the sign is going to point either up or down. Grab the arch and break it away to the side, creating an impact. The arrow should flip the opposite of what it is. If it does not flip, we are not seeing the impact switch.