Cryptopay Swiper Mounting Holes

[Dirt]

Yep. Finally going to put credit cards in the bays.
I know, a day late, and a dollar shy. Better late then never though. Good reason to raise prices too after several years.
From what I hear Yinz guys say, count up is the way to go, so have to replace the Time Master timers with LED 6's, if I can find them.
Original question... there are 2 mounting screw holes, and a slightly larger one for the wire. How do you get the square wire plug to go through the wire hole ? Can I take the plug off and put it back on ? Make the hole bigger ? I guess i'm trying to figure out how to fit a square plug in a round hole.

 

[Bricks]

Yep. Finally going to put credit cards in the bays.
I know, a day late, and a dollar shy. Better late then never though. Good reason to raise prices too after several years.
From what I hear Yinz guys say, count up is the way to go, so have to replace the Time Master timers with LED 6's, if I can find them.
Original question... there are 2 mounting screw holes, and a slightly larger one for the wire. How do you get the square wire plug to go through the wire hole ? Can I take the plug off and put it back on ? Make the hole bigger ? I guess i'm trying to figure out how to fit a square plug in a round hole.

All the ones I’ve installed have wires only, no plug.

 

[Dirt]

All the ones I’ve installed have wires only, no plug.

Oh, Ok, that's good.
The one I installed on the paystation didn't have the button, and had a plug on the wire.
The ones I need for the bays will have the button, so i'm not sure how it will look like yet.
That makes sense now because if it did have a plug, I don't think there is anywhere to plug it in to.