Could you turn an autec polisher into a normal inbay?

[CWFanatic]

To keep it simple make it have no tri foam or any other thing apart from a spray for the brushes.

 

[washnshine]

I don’t know much about them but I don’t think they have any plumbing or water/detergent manifolds, detergent delivery system etc. Even if you “kept it simple”, it needs to be able to lubricate and rinse the car and have either a water or solution feed to all brushes. I also think they are engineered to move at a much slower pace than a friction IBA. There may be engineering or design differences that prevent it from washing at the speed and robustness of an IBA.

 

[CWFanatic]

I don’t know much about them but I don’t think they have any plumbing or water/detergent manifolds, detergent delivery system etc. Even if you “kept it simple”, it needs to be able to lubricate and rinse the car and have either a water or solution feed to all brushes. I also think they are engineered to move at a much slower pace than a friction IBA. There may be engineering or design differences that prevent it from washing at the speed and robustness of an IBA.

If so do think there is a company or something or some other way like asking autec to modify the speed and just add a brush lube system?

 

[CWFanatic]

I don’t know much about them but I don’t think they have any plumbing or water/detergent manifolds, detergent delivery system etc. Even if you “kept it simple”, it needs to be able to lubricate and rinse the car and have either a water or solution feed to all brushes. I also think they are engineered to move at a much slower pace than a friction IBA. There may be engineering or design differences that prevent it from washing at the speed and robustness of an IBA.

Because I’ve seen custom mounted foam pods to brushes, so I’m assuming that it won’t be to hard just to get some generic water nozzle and pipe in and hook it up to your equipment room right?