Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Bay wont shut off???
- Thread starter coincarwash.ca
- Start date
I.B. Washincars
Car Washer Emeritus
I'm thinking the "Timed load" from the timer would need to be hot for functions to run. Unless the switch is getting power from somewhere else (CC system, manual run switch in eq. room, or whatever), I doubt the switch would be the problem. I'm guessing it's the timer or a wire touching somewhere where it shouldn't. Trace the "Timed load" wire from the timer to the switch. Disconnect it and see if the bay stops. If so, your timer is most likely bad.
I am assuming the timer is a Dixmor. If it is something else, all bets are off.
I am assuming the timer is a Dixmor. If it is something else, all bets are off.
coincarwash.ca
Washin cars in the GTA
I do have a CC system that has been disconnected for 2 years now...power is off to the control box, could this be a problem....never happened before
I also had this problem. Showed up in the morning the rinse was continuously running and it was obvious no one had washed in awhile. We replaced the timer and problem solved.
Is it allowing the use of all functions ?? or just hi pressure ??
If all functions, I would swap the timer first.
If hi pressure functions only, it could possibly be that the contactor is stuck. Or the timer
let us know what you've found
thx
oh i see now that your post say "all" the features. sorry
If all functions, I would swap the timer first.
If hi pressure functions only, it could possibly be that the contactor is stuck. Or the timer
let us know what you've found
thx
oh i see now that your post say "all" the features. sorry
