Search results

Thanks. Im looking into one of those.

Where do you put your photocells for your bay lights? Outside or in the bay? Currently outside pointed down half covered and i still feel like they come on too late. Do i need higher quality sensor? It seems to me it would naturally be a little darker in the bay, so wouldnt you want to sense...

they were brand new. No water dripping.

Forgive me here im learning. It has hot and cold going in to a tank on back of pump stand from city water press. So i assume its gravity fed. So i guess ill pull the valves and inspect.

Is this normal? Theres a slight burble or “misfire” if you will. If you cant hear it. You can see it on the guage. Its done this since i installed the new crank case and head. It was worse,it seemed to have an air leak at the soap inlet nipple, installed new check valve an tightened the...

I have actually found it through google. I have emailed a place on getting sleeves done. In fact i have 3 other heads that need done now that i know what im looking for.

Found that the failed head had a deep grove dug underneeth where the hp seal sits. Its still seems a little noisy at times. It comes an goes. Still a a light vibration in the line too. I also noticed the crank case i put on seems to generate a bit more heat than the others. Everything...

Interesting. Well maybe it was not a fresh rebuild when i installed it. Thanks for the tips. Greatly appreciated!!

Right but its a month old rebuild. I did not do the seal install. And this person is known for using used seals some times. Or it wasnt lubricated very well.

Im gonna go out on a limb an say it wiped the hp seals. Also found the crank case seals were wet with oil. I put a freshened up crank case on with new seals o-rings and copper washers and new wicks. Rebuilt head. And a rebuilt wand in the bay got rid of my vibration in the trough above...

Thanks for the tip. I hope i didnt ruin the seals by not priming it the first time.

there basically the same pump.sorry for the confusion.

Had a pump fall to 200 psi a month ago. Put on a rebuilt head that was on the shelf. I however did not rebuild it. All seemed good. This morning half way through a bay wash it dropped to sbout 600 thrn started pulsing an vibrating the trough. I shut it off then back on. 1200psi but still...

This is how ours is done. Cat 340.

Slow here in northeast ohio and it doesnt help every nice day coming up is rain. stay healthy everyone!

Thats what i figured. All 4 are in now. I just need to install needle valves. Do some fine tuning. And slso see how far i can Lean out the mix. It almost has to be a water issure to need such a rich mixture.!?

I know this. But something is keeping it from doing that. Im not opposed to using the the foam generators. I just want to understsnd why.

Yes. I made sure of it.

Ill have a look.

i still dont get why i cant do it without the generator. But what ever i got instant foam now. There isnt much in the photo. More of a runny mess.