Search results

Earl, Where can I find the Blue Bill acceptor $1 $5 $10 stickers?

Thanks!

Randy...Ill check it again, but I think it is right where the black boom hose meets the 90. Just bubbles a little there. Probably just needs tightening, but was curious what the 90 was just in case. I do have swivels at the brush end of the hose...never thought to put at the boom end. Do you...

Sorry...should have explained better. It is a new LP hose and swivel. It is leaking where the black boom hose meets the "elbow". Wondering what the "elbow" connection is and where to find it? I may just need to tighten it, but just in case was wondering what it was.

I have a slow leak where the foam brush hose connects to the low pressure boom hose. Not sure what the connection is called or where to find it.

Good idea. I can definitely sand and polish them out. I could not find the red lenses on the GinSan site. Can you send a link?

Thank you! I will try that. Would you happen to have a part # for the Lexan covers?

Dan, Yeah it is an old set up. I was just hoping GinSan had a display that I could put in that spot since it was cut into the brick to house it.

I am needing to replace my old GinSan 31 Display Timers. They are too dim and some are not showing the numbers fully. Currently have GS-401 Timers in the pump room. What model would fit in the bays to replace the GS31s?

Ended up replacing the rotary switch. All good for now.

Scott, This is an old post, but wondering what the fix was? I am having the same issue now in one bay. LP works...HP doesn't. I got it running for a few days by tightening the connections in the meter box. Then stopped working again. I am thinking it is the rotary switch.

Thank you for the detailed response. Ill try all of that.

So to start, the wax was not getting to the bays. It was backflowing back into the drum. We changed the hydro minder and it did it again, wasting two total drums of wax. Then we checked the flow from the bottom of the tank and it started drawing from the drum to the tank properly. The problem...

Thanks for the help...it was the timer

Thank you. I was thinking about replacing the timer but thought I would at least ask the question first. Thanks for the quick response.

I have 2 older JE Adams 3 motor super vacuums one door (cannot find model #, the sticker is to old). Both of them are suddenly requiring 20 plus quarters to start, what can be the problem? Both currently have a Ginsan GS-403 Timer.

There is nothing wrong with what I am currently using other than cost and having to wait on the distributor to make his route and bring it on his schedule. Customers love it and use it A LOT! At $950 for a 30 gallon drum it has just gotten too expensive. My set up is old and I only have one...

Is anyone using an all in one Presoak , bug cleaner, tire cleaner as an all in one chemical in self serve bays? If so, what are you using? I am looking for a new product. I currently run the same product on all three switches.

New problem...similar to OP so Ill keep it here. I noticed while checking all the bays (SS) to make sure everything was working before heading home that the Foam Brush was not working in one bay. So I turned through all the positions to see if anything else was not working and the Bug...

Thanks! It started working again when the temperature went above freezing. Not sure that it was the freezing temps, but thankful it started working again. But I now have a similar problem. Ill keep the question here as it may be the same issue. Will post new question below...