Search results

I’ve been replacing my IDX acceptors with slugbusters. They are fairly reliable, inexpensive, and available to purchase.

I’ve got a premier dryer on an iba. It has 2 ten hp motors on top and a 15 on each side with elephant ears. I upgraded to a stainless frame instead of aluminum. I’ve had it for 2 years. About 20k

I had a NAYAX reader go out on 4/30. Since then I have called 6 times and sent 7 emails. Finally got a call back on Friday afternoon. The guy who called was nice but he couldn’t fix my problem. He said he would turn it over to his supervisor and if I didn’t get a call back on Friday...

I would avoid IDX. You can’t buy them and the repair will take 4 months. I’m going down that road with having to replace them.

IDS is who resleeved mine. They are in Pennsylvania. Robert is the owner, he is a great guy.

I’ve had four cat 310’s bored and sleeved, they work like a new pump. $180 plus shipping

Thanks for the replies. It will give me a good place to start.

I’ve got a Crane vendor model 720. I tried to add a Nayax card reader and was told that the vendor was too old and would need a new mother board to be compatible. Any suggestions on where to have the board updated?

I have 5 Nayax readers in self serve bays. I have had them in service for 6 months. I chose them over the cryptopay after speaking with the cryptopay rep at the carwash show. I have been happy with them for the most part and I would choose them again. If you have specific questions then I...

I have been using cat 310’s to replace, I’ve been happy with them.

I have been phasing them out but I still have 3 in use. They have a lot of life left in them but are getting to the point of needing a seal kit. Seems like a shame to scrap them over not being able to find a seal kit.

I’m looking for a supplier that sells a seal kit for a Hypro 2414 pump. I tried Kleenrite, Windtrax, and Carwash superstore and none of them have any seal kits. If anyone knows who still sells these I would appreciate a shout.

I’ve been down that road and my problem was a washout. Sent the head to IDS to have bored and sleeved. Runs like a new pump.

Move the timer to another bay and see if the problem moves with it. I have had timers do strange things when they go bad.

Thanks for the help

Does anybody know a place that sells water softener resin at a good price?

Thanks for all the help. Here is where I am now. I do have led7 timers but my wiring harnesses were configured during my original install in 2003. I pulled the loop from the #9 harness and installed a new wire leaving everything else the same. I connected the #9 wire with the pulse wire on...

My wire harness has a loop wire running from #8 to #9. There is no white/black wire. I may need to update my wire harness. I hope my led7 are cc compatible

Please help. Today I connected my Nayax vpos to my led7 timer. I connected 3 wires, the 24v plus, the 24v minus, and the coin signal. Upon startup the Nayax would not read a card, it did read the Nayax supplied card and went into count up. None of the wash functions would start and the led7...

I’ve used IDS on several Cat 310 heads. They do a great job. They press in the stainless rings so that you use a regular seal kit.