Recent content by WyoWaterWorks

I'm pulling out a working DS Super 5000, in a few weeks in SW Wyoming. I also have some extra parts, like Hydraulic pump unit, a spare carriage that is just bare bones.

I called the 800# and it say's call back during M-F during office hours, so I will keep hammering at it until I hopefully stumble on a fix. I will try them again on Monday, it's hard to find support on this old of a machine. I'm sure it has something to do with loading the washes somehow?

I have the password, thought I had added another rinse but now I have a Recipe Error and the wash wont do anything!!! I should have left it alone, dang it!

Sorry for the late response, I found a bad feedback cable for the drivers side gantry home prox switch the machine is running pretty consistant now. I do have another question does anyone know how to edit the washes or have a screen shot example on how to edit the washes? I would like to add...

I have an Encoder that counts, I just replaced it to see if that was the issue, and it wasn't that. I have changed out the passenger side proximity switch and wiring harness, I will change out the drivers side and see if that helps. We are located in Marbleton Wyoming.

Unfortunately I'm still having the same issue, after a couple washes the gantry seems to always get a little off home but the home sensors are still lit up just barely on the drive wheels. I'm not sure if this is related but sometimes during the wash cycle the gantry doesn't travel down to the...

yes the re-home works fine and 5000 is the home. I just ran the gantry to complete stops on entry and exit the numbers were only of by 1. I did this 3 times. I had done the re-set to get the gantry and carriage both at 5000, and still have the same issue. Sometimes it just soaps up and then...

I'm new to the car wash business only 3 years in, and I'm fighting a Gantry failed to home problem with a DS Super 5000. The wash will run about 4-6 test washes and then stop, flashing (F1 and gantry failed to home message). Things I've done so far listed, traced wiring looking for bare...