Recent content by rshiggaon

Hello Everyone: I’m using a Ryko SoftGloss Maxx 5 with a ColorWave application that’s generally performing well. We’re dispensing Carnauba wax, and water rinse during the reverse pass through through the rain bar. However, during the drying pass, I’m still seeing a few diluted product residue...

I have a Ryko Softgloss Max 5 (SGMX5 FX3U) model. Currently, we don't offer the pre-soak chemical. The machine does a decent job overall, but I still notice bug spots on the bumper and a few other areas. I'm considering enabling the pre-soak feature to help with this. Has anyone here enabled...

Thank you. Do you know where I can find 1/4-inch black nylon tubing that’s UV stabilized? Kleen-Rite is currently out of stock. If you have a link, I’d appreciate it if you could share it.

I’m looking to replace the air hoses in my self-serve bays and would appreciate your recommendation on the best long-lasting option. Should I consider the more affordable black poly tubing, such as this one...

I did replace all the HP seals last time. But thank you for your thoughts.

I checked the pre-soak bypass solenoid, and it was not opening—nothing came through it when the rinse function was activated. I also tested the high-pressure regulator by installing a new one, but the issue persisted. The CAT pump valves appeared fine; I cleaned them thoroughly and reinstalled...

Planning to do it end of this year. Did you make it come out of the trigger gun or triple gun?

Good Point, will do and update here. I dislike the presoak setup on JC; it's overly complicated. I wish they had done it the same as the tire cleaner.

Maybe less than 1 year old. I have 1508 tip.

Yes, it does not change. I forgot to mention it.

Hello, A few of my pumps are currently reading around 975 PSI when the trigger is pulled and about 1300 PSI when the trigger is released. I have JC set up, and three months ago, they were reading a consistent 1100 PSI. There is no noticeable pulsation in the system. Is it normal for the...

Thank you for all the advice. Just replacing the filter and diaphragm did the trick for me. But I have kept a spare too. Always keep learning here!

Yes, it's the JC tank. It's been a while since this float valve has not been replaced. I got it from the seller. Thank you for the advice.

Hey everyone, I need to replace my float valve—it’s leaking. I’ve attached a pic of the current setup. I know it’s a 1-inch valve. While searching on Kleen-Rite, I came across a couple of options: Topaz Standard Float Valve with Long Tail Topaz Float Valve with Detachable Base and Short Tail...

Yes it did for Bay1, this is the first time it happened. I dont think so it supports 16 amps right?