Recent content by NessaForever

It’s time to finally switch to from the XE validators on my Hamilton DRS to Mars (which bill acceptors can I use now that they switched to Talos). Can anyone point me in the right direction on what I need to order to make the conversion? Thanks

Thanks. Think I’ll use the filter/regulator combo to control the flojet for chemical solenoids and then tee off and use just a regulator to control the air solenoids. Sounds right?

makes sense. Thank you. I have a combo filter/regulator so I can use that one for chemical and then get another regulator for air.

so need a regulator for both? The filter I was using had regulator built in.

I’m probably overthinking this but wanted to make sure. I have my air line from compressor going into my filter/regulator on my tire cleaner setup. Do I tee the air line out of the filter/regulator with one line going to the air solenoids and other line going to the flojet? I am not using a...

The previous owners had flojets with these controllers for foam brush, tire cleaner and presoak

thanks. The previous owners actually had flojets working with these controllers.

Yeah I know they won’t be exactly the same but I think I can get them to work to connect to my master air solenoid

Thank you.

Does anyone know of a replacement for these controller from DH? I’m guessing I could probably use a IDX Multiplexer? thanks

Thank you for the feedback. That’s a good idea. There looks like a little crack the holds them up but a camera will be able to tell me for sure. I think I know someone that has one. I appreciate it.

We inherited a car wash that has 6 bays with the round major/star safes in the walls below the meter boxes facing the front of the wash. Bays 2&3 and 4&5 share the same safe. The quarters travel down an angled pvc pipe into the safes from the meter boxes. The issue we are constantly having is...

Just curious if anyone had any tricks or tools to keep the sensors tightened? It’s hard enough to get any wrenches in there to tighten all the proximity sensors much less keep them tight. Someone mentioned to me a while back about a small tool that would help tighten them but I cannot find the...