Recent content by MonroeStreetPowerwash

We have it connected to the Unitech Wash Select 2. The directions were accurate and it went together fairly quickly. We offer to dispense a token for every automatic wash and I believe its configurable to not offer a token for a specific wash and more than 1 token for a specific wash. We...

It was about 3 years ago and I believe I paid 1700.00 for it

I installed the CP token dispenser as it was the only one that required a button push for the token. If I had to guess it would be roughly 30% of the people do not want the token. I have been pleased with it. Only issue I have really is the size of the hopper holds around 400 tokens, but that...

I just went through this also with Unitec where the costs would have been around 4K per vacuum to include the costs of getting Ethernet to the Vac. Wound up going with Cryptopay for just the vacs and added them to the vending machines.

Just did that. New meter boxes with bill acceptors, used 3x foam system and air shammes for the bays

Interesting question. I have quite a bit of automation already for the wash, but have not really figured out a good solution to this. At one of my sites I am putting in 3 new functions (3x, Air Shamme and Tireshine) and will be running the 24 volts inline to a on/off switch, hour meter and...

I am impressed and like your idea for the pressure boost button. Can you share any details on your setup on how it works?

Following the recommendation from (Almaprowash ) I went with the blue light mounted to the ceiling 144 watt and it comes on during the presoak. Definitely provides the Wow factor. I also have the yellow light that I use for the top wax and its not nearly as bright and visible to the customers...

On my Futura Revolution, the userid is master and the password is control

With some input from Dognet, I was able to track down a solenoid in the arch that was causing the problem.

Thanks for the response. When the High pressure wash ends for each type of wash it has already done the passes for the presoak and soap and depending on the wash programming could be at either end of the wash and the error has happened at both ends of the wash. Will take a look into the drive...

Would you be able to describe what you found is the problem. I have a similar issue where after the high pressure wash or rinse ends the pass it will short out something and reboots the touch screen. I would guess its a solenoid somewhere but not sure which one. Thanks John

Everywhere I check there is a long lead time.

Checking to see if anyone out there would know where to track one down? The part number that I need is ( Bi12-EM30EWD-AN6X 0.2M-RS4T), which I believe has been superseded by the new part number (BI15U-EM30WD-AN6X-0.2M-RSV 4T)