Recent content by Henry

I got a call from the local distributor today. They said they had got a call from Mark 7 and that the switches would be made up and sent out ASAP. Go figure! I didn't know KR did custom decals. Thanks for the information.

We've considered the 10 position option but one would think that the switches we need could be purchased somewhere. Mark 7 or elsewhere. After all, they're only 3 years old so we're not talking about some antique setup. Converting would be an expensive option since the faceplate decals are...

The trick is to slide the tokens in at an angle! Use a tube, tip it over at a 45 degree angle, and pour them into the standard quarter wrapper tube. The rolls won't be exactly square on each end but they'll work just fine.

I've had this happen before. The problem is not with the spring tension, it's dirty rollers and belts that pull the bill up into position to be inserted into the bill box. Most likely the belts. Bill acceptors pull in bills with all kinds of crud on them. Ever get greasy bills from some guy...

We have an 8-2 that was completely rehabbed in 2005 using Mark 7 Proline equipment for the self serve bays. Each bay has an 8 position rotary switch where all 8 positions are used for a function (no stop position). Three of the switches are getting worn and no longer click from position to...