Recent content by GoBuckeyes

Thanks for all the suggestions. It wasn't too bad. Getting the old hose out was twice as hard as getting the new one back in. The dividers between the polylines and the HP hose were tight to the HP hose and kept getting hung up on the spiral wrap. Our bay width doesn't help either. We're...

Apparently our Razor V4’s high pressure hose blew out today in the e-chain and needs replaced. My brother looked at it today and said it wasn’t straight forward as to how to go about getting it out. On our old Typhoon the E-Chain snapped open, but he couldn’t figure out how or if the Razor...

I have those but not all of our bays have cryptopay yet.

Does anyone have another brand of remote control that will work for the Dixmor Timers? The Remote sold by Kleen-Rite for $34 which can be bought on Amazon for $6 simply doesn't last for us. There is something unique to the Power button that will fail within a couple weeks of use. If we...

Thank you! I applaud you...that's not an easy feat.

I’m using Quest and getting good results but the eyebrow is still an issue depending on the weather. I’ve been working with them and trying some new stuff that they are trying to develop. I like the fact that they’re proactive and want to improve. Everything is a trade off….Cost versus Clean...

I was given a 30 gal drum of Wildfire to try. I don't recall the tips I ran.... but I kept making it progressively stronger and didn't see an improvement. Actually, went back through some texts and it looks like I was running two passes with green tips using .086 injectors. We were getting...

They can afford a corvette, a nice F150 or 250 or 350 plus 4 more vehicles and are printing money at their restaurant but need to rip you off? Their busy restaurant would have a cockroach infestation if I lived there.

When that happens have you checked the outputs? Is the contactor for the trolley pulled in like it is trying to run the trolley motor? If so, it could be losing a leg at the commutator. The rings and brushes can eventually wear and cause intermittent loss to one or more circuits.

Cleveland, Ohio Bay $4 Start Bay $1 / Minute Vac $2 / 3 minutes

I’m exhausted after reading that😵‍💫

Why not just buy the stack kit? Are the components individually that much less expensive?

My thoughts are that they consider a closed loop system a pressurized system whether you have it pressurized or not. The point is that it could build pressure and if it did you're relying on the psi relief to relieve that pressure to prevent an accident, hence the required inspections. A long...

Our Town…I am also in Ohio. Here is what we did and what I suggest you do. We have several washes with Raypack floor heat systems designed by Huron Valley. Our one air-x tank rotted out so I replaced it with an open top square plastic tank with a lid. When the inspector came back the next year...

Nobody has any idea how long their truck is and they all seem to forget about their trailer hitches. The sign is just to cover your ass. Even with a rear eye, the trailer hitch will usually slip through. If they're just straight and long they usually won't hook the spray bar. If they have the...