Recent content by djlamp17

I had an instance of a van leaving the washbay before the wash ended and the van caused some damage. The Gantry was at the front of the van at start of wash, and the van pulled forward, out of the wash area. the Gantry continued to tavel to the rear, and stopped cuz no vehicle detected. The...

Looks like the tilt sensor was the issue...chased it to a kinked wire in gantry..I need to replace the wire. Thanks for the tip!

Thank you... I will check out the tilt sensor

That didn't take long here it is. The video of the machine https://photos.app.goo.gl/qKGZdVeXGkdDC8fu7

I tried to get a video of it yesterday, and it is an intermittent problem...works fine right now..🤷‍♂️ I will wait for it to fault which will happen over the weekend and upload a video....the machine does operate as you state above... But looking at the video, i do not see X42 of X43 lighting up.

All ultrasonics are up in the gantry...I have photoeyes on the walls. ...will get a video tonight

So here we go again :)...i do enjoy learning and fixing these problem. So the OHD faults on the passenger side front of the car at the initiation of PASS 1. I am sure it is a sensor or proxy...so I attached a video of the IO panel....any help my friends...

Actually I was able to push the unit to center...and no change in issue

I removed wires...how do I manually move? Do I need to physically disconnect the belts and push the gantry to the middle?

Hello all...another fun one with the Ryko 2001 OHD overhead unit. received a customer call the wash went down, the gantry is stuck near the rear of the vehicle. I turn the unit to "Closed" to try to 'Home' the system. The gantry will only move in the rear direction, and there is less than a...

https://photos.app.goo.gl/eaFvPpHyzoUw3R2B6 See if this picture works..

I am having an issue...When the doors open for normal operation...they get about 80% open, then close automatically and repeat this until the car either goes thru or backs off the sensor. I can override with the E-stop and the doors completely open. I had a relay timer go bad (the OMRON H3cA)...

Pump rotataion confirmed in correct direction

Djlamp@hotmail.com

Pump rotates clockwise...seems correct...i am not getting any water to flow...air is flowing for all booster pump proccesses...presoaks, trifoam and spot free rinse. No more breaker trips after i replaced the valves. A little bit of trickle comes from OHD...some main valve is bad...which one?