Recent content by Alberta north

This is what we did when we built in 2004 works great for the IBAs But for big trucks it just slows them down

Yes $1 for 60sec Our truck wash we use a timer only at $1.25 min We get lots of big washes that go from 30 min up to 4-5 hrs

Alberta $1.00 /min carwash $1.25 /min truck wash $0.75 /min vacuum

It’s very easy to set the open and close limits. This is setup on a 10x10 door with a wash world profile IBA. We didn’t get the chain backup not sure how we would open the door if the power went out. http://gatesanddoorsinc.com/upload/productcategory/Brochures/HAML_2_pager_V1.04.pdf

I put this in our wash last year. so far it works great I will put pics of the installation tomorrow http://gatesanddoorsinc.com/home/productsfamily/HAML

I made a custom bucket it works great.I also dump outside and let it dry.

Ok so ive done a network test and it shows ok. Also turned the run/stop switch off and on. I used the hand held earlier this morning and reset M815. Still getting the error code 15. I have tried reprogramming the CAW 4 and when I looked in the manual I can't get the network arming. I don't...

Yes a couple of times. Everything turns on as normal. The lights on the input and output list are good for about 3 min then output lights y20 though y24 go out. Which is CMD 1,2,4,8,16 .

Getting a error code that is saying no response from IFSF network module. Last night we had a lightning storm and now there is no memory in the code a wash 4 ?

It sounds like you lost power on one leg. Put a clamp meter on each leg to see how many amps your drawing. If you have no amp draw on 1 of the legs you could have a broken wire. That will also tell you if your motor is drawing too many amps causing the vfd to overload.

My wife and I are going to Vegas April 25. Hope to see lots of machines there to compare. Went through a Ryko soft gloss last month but don't have anything to compare it to. As of now we have a Ryko 2001ohd machine and 8 ss bays with 2 truck wash ss. One thing I did like with the profile was...

My experience is bite the bullet, rcmp, peace officers don't do anything. Do it hands on, we have kids that park outside throwing garbage out, I was there and seen them so I boxed them in with my truck. Grabbed a garbage can from inside and stood out front and told them to start picking up...

Looking at doing a friction IBA there are two suppliers that I'm interested in. Ryko soft gloss maxx and the wash world profile. Does anybody have experience with either of the machines to help make my choice? Pros? Cons? Repair costs?