Wash Select II questions - Auto Shut Down?

[millertime355]

Here's the setup:

Vector with Deluxe Door Control Package (timed wash shut down)
Wash Select II

The Vector's door control package has time settings to shut down wash. Problem is, it only shuts down the safety eyes on the doors so that no entrance can be made using the eyes.

Does anyone know of an input on the Wash Select II that can be used with the n/o contact in the belanger equipment to disable the Wash Select without having to power it down.

 

[John Spokas]

In your Deluxe Door Control cabinet there is a "Wash Close CR3" Relay located to the left of the terminal strip. CR3 has two sets of contacts connected so that they can be wired using the terminals on the bottom. Pick either the left two or the 3rd and 4th and connect X34 (Wash Closed Input) in the Vector MCC and 338 (0VDC) in the Vector MCC.
When the Deluxe Door Control is after hours, CR3 will send a signal to X34 and the Vector controller will toggle the Wash In Use signal to the Wash Select II and the WSII display will read wash out of service. No money, credit cards, or POS4000 codes will be accepted but sales can still be carried out at the pumps and in the "C" store.

 

[John Spokas]

"In your Deluxe Door Control cabinet there is a "Wash Close CR3" Relay located to the >left< of the terminal strip." Oops, CR3 is to the right of the terminal strip.....

 

[millertime355]

Thanks

I was thinking that would be the case, but don't have any of the manuals with me. Just popped in my head, and wanted to make sure that would work.

Tomorrow I could have tried it, but figured somebody on here would answer my question so I could stop thinking about it.