BPAutoLaundryMatt
New member
Hello everyone,
I am currently taking over the operations of an old Hanna Tunnel system which had fallen under a state of disrepair and deferred maintenance. We are making decent progress going through the car wash piece by piece and fixing or replacing the necessary equipment but are getting caught up with the controller system. It's an old Hanna tunnel controller with Compuwash system which I believe dates back to the early 2000s. We have the old controller box however can't get it to communicate with the main board. The board will light up but not send the signal.
Does anyone have any advice? Would be amazing to find an old owner's manual or computer software that might pair with this.
Is it possible to bypass the remote controller to utilize different wash packages without replacing the entire controller?
Thanks everyone
I am currently taking over the operations of an old Hanna Tunnel system which had fallen under a state of disrepair and deferred maintenance. We are making decent progress going through the car wash piece by piece and fixing or replacing the necessary equipment but are getting caught up with the controller system. It's an old Hanna tunnel controller with Compuwash system which I believe dates back to the early 2000s. We have the old controller box however can't get it to communicate with the main board. The board will light up but not send the signal.
Does anyone have any advice? Would be amazing to find an old owner's manual or computer software that might pair with this.
Is it possible to bypass the remote controller to utilize different wash packages without replacing the entire controller?
Thanks everyone
