Pdq M5

[stud]

I am having an issue with an M5 on-board dyer. After the spot free pass I get water dripping out of the nozzles for what I consider a long time and during the dry with the arch pointing over the vehicle the water is dripping on the vehicle. I cannot have the arm pointing towards the entrance of the bay due to abstruction. I thought the M5 blows out the spot free after the cycle and before it starts the drying process but this machine is not doing it. Is there somthing in the programming I am missing?

Any help would be greatly appreciated.

 

[jcollins]

Yes, it can be programmed to blow/purge the water out of the arch before the drying pass. Use the "help" icon at the top of the browser, the setting (about 20 seconds to purge) should be on the dryer page in "setup" , .....but may be on the wash package setup.