older pdq 4000 runs fine, occasionally after vehicle completes the wash and pulls up to dry entrance will read wash in use? reset with joystick and or jo works for many washes and fails again? t bar breakaway switch totally disconnected so no trouble there. jo sometimes faults with st wheel well rt. anybody have an idea?? only happens on very busy days..
Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
laser 4000 in use
- Thread starter dwolfe
- Start date
MEP001
Well-known member
Did you ever fix this problem?
www.carwashforum.com
Laser 4000 issues
Have a Laser 4000 issue, arch prox replaced due to failure, x32 not lite in jo however jo reads wash bay in use, reset enable still same rebooted still same issue any thoughts out there?
www.carwashforum.com
The Startup Test Wheel Well means that the X31 input was on during a startup test. This causes the machine to believe there is a vehicle in the bay. Unless you have 20C in your A5000 this will shutdown the car wash until it is forced to do a new startup test and sees the problem cleared.
If you have a treadle then you should check the bumper, wheel well prox and cable.
If you have a VT then check the stop eyes, cable and VT card.
If you have a treadle then you should check the bumper, wheel well prox and cable.
If you have a VT then check the stop eyes, cable and VT card.
Bolt was bent as well as the lower 2ft of the arch , no idea who did that but must of trashed their vehicle too. Removed the arch took it in my shop had to set it up on my press and straighten. The backup eye was blocked. 
Customers are the worst and best at the same time. Thanks all
Customers are the worst and best at the same time. Thanks all