Belanger kondor Kl1
- Thread starter Washohio
- Start date
DakotaHoskins
Active member
We don’t have a one arm Kondor but one 2 arm saber, one 2 arm kondor, and 2 freestylers. The touchless units just don’t have a lot go wrong with them. Most of the parts are interchangeable. I would stock some entrance/exit proxes, and smaller butterfly proxes/cables. An extra sonar wouldn’t be a bad idea either. All the bearings can be sourced from local auto parts store.
MEP001
Well-known member
I'm only familiar with the Belanger Vector, and my spare parts list would be the same plus a spare photo emitter/receiver set, spare proxes, maybe a spare encoder card, and obviously spare hoses. I replaced the overhead lines with stainless steel pipe made so that each joining hose was 36", the same length as the ones to the arms. It was a half-day job (and an expensive one) to replace one of the boom hoses, but it only took five minutes to change a short length.
