belanger

Hey everyone, looking for some insight on a visibility/safety issue. We are running two Belanger Saber dual-arm touchless units where both wax and drying agents are applied through the arms. Noticing on my own vehicle, a heavy, greasy buildup on windshields. . I suspect the glass isn't getting...

Hello! I have three Automatic Car washes : one Belanger vector and two Washworld Razor Two Razor was installed recently and Razor’s Can be controlled remotely using washview remote net on my Computer I have a question, can I control Belanger Vector remotely and if so , is there an application...

Hello! We have an old Belanger dura trans XD conveyor, what could be causing the chain to slip off the sprocket? - chain tension from the pressurized air cylinders is good - the entire take-up assembly seems to be turning/tilting to one-side before the slip occurs - bearings seem to be okay...

Hi Folks, Just wondering if anyone her have a spare Vector PLC? Mitsubishi FX2N-64MT We've got an older vector rapid wash (2 Arm) and looks like the PLC is fried and needs to be replaced. Will still have to find the root cause as to why it fried all of the sudden... We did get GFCI faults x2...

Please Help, Currently have a Belanger Inc Vector Car wash setup. I went to change the Prox sensor on the treadle, so I turned off the system, Swapped it out and after I turned it back on, the system won't Jog or move anymore, I figured sure I'll swap the sensor back and it will work again but...

Good Morning, I currently have the Belanger Quick-fire with air controls. The system is fairly new its about two year old! I'm having some issue dialing the system in to clean the car properly. My current issue is where the cylinder sits, the cylinder valve is getting submerge in water in the...