Search results

Hey all, experiencing an issue where every so often when a loonie gets inserted it counts as 16 pulses rather than 4. Is this an issue with my icoin sending too many pulses to the dixmor led 7 timer? Thanks for the help.

Good day, We use an Exacta Paymaster system to dispense our gift cards. In our last batch of gift cards I noticed a row of cards that seemed to almost have a static cling to one another. In some circumstances I am noticing that the car dispenser is having a difficult time dispensing the gift...

Tested that and it made no difference. Think I finally figured it out. 24v steady from the black wire coming from the emitter into terminal 5. When the receiver drops voltage the emitter maintains it so the limit switch doesn’t activate. Removed the black emitter wire from terminal 5 and all...

I was surprised to find voltage in that line....could be on its way out.

Think I finally figured it out. 24v steady from the black wire coming from the emitter into terminal 5. When the receiver drops voltage the emitter maintains it so the limit switch doesn’t activate. Removed the black emitter wire from terminal 5 and all seems to be good. Will keep you updated if...

Appears I have not been successful in finding the solution. Photo eye stopped working again today. Yesterday I check it out and there was a delay between when I broken the photo eye "beam path" and when the door went back up. After doing this a few times it became quicker. Today I went there and...

Appears I have not been successful in finding the solution. Photo eye stopped working again today. Yesterday I check it out and there was a delay between when I broken the photo eye "beam path" and when the door went back up. After doing this a few times it became quicker. Today I went there and...

Appears I have not been successful in finding the solution. Photo eye stopped working again today. Yesterday I check it out and there was a delay between when I broken the photo eye "beam path" and when the door went back up. After doing this a few times it became quicker. Today I went there and...

thank you for your help!

Red Wire was loose and not sending the signal. Thank you for your help!

0vdc as in grounding it?

I will go today and get better pictures. Is there a way to test the signal wire to make sure the receiver is sending the signal? should I try to connect the white and red wire? Is there a risk of harming anything?

NC is what is in brackets on the board. I will go today and get better pictures. Is there a way to test the signal wire to make sure the receiver is sending the signal?

which wire should I remove? The red, white or both? Should they be connected to another place?

yes, with the manual control buttons I can reverse, stop, lower the door. It is also wired to raise the door 30 seconds after someone enters the bay if they do not put money in to activate the bay. It also raises at the end of the wash. All these functions are working, just not the photo eye.

Here is the wire set up: Brown wires- 24vdc + Grey and Blue wires- 24vdc - Black wires- Photo (NC) Red and White wire- runs from Photo (NC) to limit switch. Is there a way for me to check to see if the signal from the receiver is making it to the board? Should I bypass the limit switch? The...

I do not have a good diagram.Which wires are the limit and signal? Sensors are installed correctly and switched to new ones. Also installed a new cable to the receiver. I’ll post pictures.

Internal